Street lamp in the installation process of debugging work is very important, so the LED street lamp in the system debugging process, what tips can be applied, the following about the LED street lamp in the system debugging skills, to understand the relevant instructions about the LED system debugging.
Before the LED street lamp is installed and hoisted, the battery should be used for another test to see whether the lamp can be lit, so as to avoid being found after the hoisting is completed and increase the cost of installation and debugging. What are the skills in this process?
1. Time control function setting. According to the daily lighting time designed in the design scheme, set the time control point according to the instructions of the controller. The lighting time every night should not be higher than the design value, but only equal to or less than the design value.

2. Simulation of light control function. If it is in the daytime, the light facing surface of the solar array can be completely covered by an opaque object after wiring (or the wiring of the battery module on the controller can be removed). According to the delay time mentioned in the controller manual (generally 5min), see whether the lamp can automatically light up after the corresponding time. If it can be turned on, it means that the light control on function is normal. If it cannot be turned on, it means that the light control on function is invalid. It is necessary to check the setting of the controller again.
About the LED street lamp in the process of debugging which tips can be used, the relevant instructions for you to introduce here. If you have any questions, you are welcome to contact us. We will keep updating more relevant content for you.

https://www.diecastingmanlighting.com/product/led-street-lighting/